If you are looking for Kites and Trapezoids Worksheet Answers, you will want to know the ways to create your Kites and Trapezoids Worksheet. Below are the ways to create your Kites and Trapezoids Worksheet that will help you on your path.
Kites and Trapezoids Worksheet: This worksheet should be made up of many different steps that you can do at home. If you are already doing these things, then there is no need to purchase a Kites and Trapezoids Worksheet. Just remember to take your time and be careful as this could be your very first project!
Step One: First, you need to have a craft knife. Make sure you have put a piece of tape over the blade. Hold it about three feet away from the ground so you can move it without being seen. You will cut the paper into quarters. Cut one-quarter to create two triangles and one to create one.
Step Two: With the scissors, cut one triangle and one-quarter and place them into a smaller pot and stick into the ground in between two trees or rocks. You can create a tower by wrapping your two pieces and putting them in a second pot. This will become the apex of your tower. Roll each piece into a ball and roll the ball into the other piece.
Third Step: Place the stack of kites into another pot and remove the ball. It can look like there is a missing base. This is a way to make the tip of the kite. Take your pencil and cut off the triangle so that you can see the tip of the kite.
Fourth Step: The tip of the kite can be made from either paper or metal. You can cut out a small portion to make a bit of the piece. You can also cut out all the sides of the kite. You can create a kite that has the lines of the letter A, B, C, D, E, and F.
Fifth Step: To make the tail of the kite, put a section of a rough piece of wood, and make a circle with the end of it. You can then tape a small piece of rubber band around the end of the circle. This will allow you to create the tail of the kite. When the rubber band is attached to the circle, twist it so the yarn has ends on one side and the tails on the other.
Sixth Step: Take a heavy piece of metal and hammer it on both the center and the bottom of the square that you created. Continue hammering the metal until it turns into two slabs. Put the metal on the second square and take a piece of felt and cover the holes that were created by the metal that was placed over the holes. You can glue it to the outside of the square. To attach the felt to the top of the first square, pin it on the back side to the metal.
